26
Super X11SCE-F User's Manual
Installing a Passive CPU Heatsink
1. Do not apply thermal grease to the heatsink or the CPU; the required amount has
already been applied.
2. Align the four holes of the heatsink with the four mounting holes on the motherboard.
3. With a Phillips screwdriver, gradually tighten screws #1, #2, then #3, #4 to assure even
pressure. The order of the screws is shown below. To avoid damaging the processor or
socket, do not use a force greater than 12 lbf-in when tighthening the screw.
4. Examine all corners to ensure the heatsink is rmly attached to the motherboard.
Mounting Holes
Screw#1
Heatsink Bracket
Recommended Supermicro
heatsink:
SNK-P0047PSR
Motherboard
Screw#2
Screw#3
Screw#4
To Next Page
Loading...
