Supermicro X11SCE-F - Page 58

Super X11SCE-F User's Manual
58
Fast Boot
Use this feature to enable or disable fast path through the memory reference code. The
options are Disabled and Enabled.
REFRESH_2X_MODE (Available if supported by the CPU)
Use this feature to select the refresh mode. The options are Disabled, 1-Enabled for
WARM or HOT, and 2-Enabled HOT only.
ECC Support (Available if supported by the CPU)
Use this feature to enable or disable memory ECC support. The options are Disabled
and Enabled.
DMI/OPI Conguration
The following DMI information will display:
DMI: X4 Gen3
DMI Link ASPM Control
Use this feature to set the ASPM (Active State Power Management) state on the SA
(System Agent) side of the DMI Link. The options are Disabled, L0s, L1, and L0sL1.
DMI Extended Sync Control
Use this feature to enable or disable the DMI extended synchronization. The options are
Enabled and Disabled.
DMI De-emphasis Control
Use this feature to congure the De-emphasis control on DMI. The options are -6 dB
and -3.5 dB.
PEG Port Conguration
PEG Port Conguration
PEG 0:1:0/PEG 0:1:1/PEG 0:1:2
Enable Root Port
Use this feature to enable or disable the PCI Express Graphics (PEG) device in the port
specied by the user. The options are Disabled, Enabled, and Auto.
Max Link Speed
Use this feature to select speed for the device installed in the specied port. The options
are Auto, Gen 1, Gen 2, and Gen 3.