Supermicro X11SCE-F - Page 68

Super X11SCE-F User's Manual
68
Serial ATA Port 0~7 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Serial ATA Port 0~7 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disabled and Enabled.
Serial ATA Port 0~7 SATA Device Type
Use this feature to specify if the SATA port specied by the user should be connected to a
Solid State Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCH-FW Conguration
PCH-FW Conguration
• Operational Firmware Version
• Backup Firmware Version
• Recovery Firmware Version
• ME Firmware Features
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
ACPI Settings
WHEA Support
This feature Enables the Windows Hardware Error Architecture (WHEA) support for the
Windows 2008 (or a later version) operating system. The options are Disabled and Enabled.
High Precision Event Timer
Select Enabled to activate the High Performance Event Timer (HPET) that produces periodic
interrupts at a much higher frequency than a Real-time Clock (RTC) does in synchronizing
multimedia streams, providing smooth playback and reducing the dependency on other
timestamp calculation devices, such as an x86 RDTSC Instruction embedded in the CPU.
The High Performance Event Timer is used to replace the 8254 Programmable Interval Timer.
The options are Disabled and Enabled.