Supermicro X11SPG-TF - DIMM Installation; DIMM Removal

35
Chapter 2: Installation
+
+
SAN MAC
IPMI CODE
BIOS LICENSE
DESIGNED IN USA
MAC CODE
X11SPG-TF
REV: 1.01
BAR CODE
JPWR6
JUIDB1
JPWR5
JPI2C1
JL1
JOH1
JPME2
JWD1
JPG1
JP1
JPTG1
JPCK1
LE1
LE3
LEDM1
LE2
LE4
FAND
FAN1
FAN2
FAN4
FAN3
FANA
FANC
FANB
S-SGPIO1
I-SGPIO2
JP3
JP2
JBT1
MH12
MH10
JTPM1
JSD2
JSD1
JIPMB1
JNVI2C1
JRK1
JSTBY1
BT1
SP1
JD1
I-SATA7
I-SATA6
I-SATA5
I-SATA4
S-SATA1
S-SATA0
JF1
JP4
SXB2A
SXB1A
M.2-H_2 PCI-E 3.0 X4
SXB1B PCI-E 3.0 X16
CPU SLOT3 PCI-E 3.0 X16
SXB2B PCI-E 3.0 X16
USB1
M.2-H_1 PCI-E 3.0 X4
USB4/5(3.0)
USB6/7(3.0)
USB8(3.0)
USB2/3
COM2
LAN2
VGA
CPU
LAN1
DIMMB1
LEDLED12LEDFAIL
ON
DIMMA1
NMIXPWRHDDNICNICUIDPSRSTPWR
DIMMF1 DIMME1 DIMMD1
DIMMC1
IPMI_LAN
USB0
Aspeed
AST2500
Intel
C621
Intel
X550
DIMM Installation
1. Insert the desired number of DIMMs
into the memory slots based on the
Recommended Memory Population Guide
table on page 32.
2. Push the release tabs outwards on both
ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the
receptive point on the memory slot.
4. Align the notches on both ends of the
module against the receptive points on the
ends of the slot.
5. Press the notches on both ends of the
module straight down into the slot until the
module snaps into place.
6. Press the release tabs to the lock positions
to secure the DIMM module into the slot.
DIMM Removal
Press both release tabs on the ends of the
DIMM socket to unlock it. Once the DIMM
module is loosened, remove it from the
memory slot.
Release Tabs
Notches
Press both notches
straight down into
the memory slot.