35
Chapter 2: Installation
Removing the Processor Carrier Assembly from the Processor
Heatsink Module (PHM)
To remove the processor carrier assembly from the PHM, please follow the steps below:
1. Detach four plastic clips (marked a, b, c, d) on the processor carrier assembly from the
four corners of heatsink (marked A, B, C, D) in the drawings below.
Pin1
Pin1
A
B
C
D
a
b
c
d
Processor Carrier Assembly
(Reverse Side View)
Heatsink (Reverse Side View)
2. When all plastic clips are detached from the heatsink, remove the processor carrier
assembly from the heatsink
To Next Page
Loading...
