Supermicro X12DPi-N6 - Page 83

Chapter 4: UEFI BIOS
83
Wait For 'F1' If Error
Select Enabled to force the system to wait until the <F1> key is pressed if an error occurs.
The options are Enabled and Disabled.
INT19 Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this feature
is set to Immediate, the BIOS ROM of the host adaptors will "capture" Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this feature is set to Postponed, the ROM BIOS of the host adaptors will
not capture Interrupt 19 immediately to allow the drives attached to these adaptors to function
as bootable devices at bootup. The options are Immediate and Postponed.
Re-try Boot
When EFI (Extensible Firmware Interface) Boot is selected, the system BIOS will automatically
reboot the system from an EFI boot device after an initial boot failure. Select Legacy Boot to
allow the BIOS to automatically reboot the system from a Legacy boot device after an initial
boot failure. The options are Disabled, Legacy Boot, and EFI Boot.
Power Conguration
Watch Dog Function
Select Enabled to allow the Watch Dog timer to reboot the system when it is inactive for more
than 5 minutes. The options are Enabled and Disabled.
*If this feature is set to Enabled, the following feature will display:
Watch Dog Action (Available when "Watch Dog Function" is set to Enabled.)
This feature allows the user to determine how the watch dog timer should respond or
function after it is triggered. The options are NMI and Reset.
Front USB Port(s)
Select Enabled to allow the specic type of USB devices to be used in the front USB ports.
Select Enabled (Dynamic) to allow or disallow this particular type of USB devices to be used
in the front USB ports without rebooting the system. The options are Enabled, Disabled, and
Enabled (Dynamic).
Rear USB Port(s)
Select Enabled to allow the specic type of USB devices to be used in the rear USB ports.
Select Enabled (Dynamic) to allow or disallow this particular type of USB devices to be used
in the rear USB ports without rebooting the system. The options are Enabled, Disabled, and
Enabled (Dynamic).