12
Super X12STL-F User's Manual
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacturing Mode Pins 1-2 (Normal)
JVRM1/JVRM2 VRM SMB Clock (to BMC or PCH)
Pins 1-2 PCH (Normal)
Pins 2-3 BMC (Normal)
JWD1 Watchdog Timer Pins 1-2 (Reset)
Connector Description
BT1 Onboard Battery
COM1/COM2 COM1 (Port), COM2 (Header)
FAN1 ~ FAN4, FANA/FanB System/CPU Fan Headers
I-SATA0~I-SATA5 Intel Serial ATA (SATA 3.0) Ports (6Gb/s)
I-SGPIO1, I-SGPIO2 Serial General Purpose I/O Headers
BMC_LAN Dedicated BMC LAN Port
JF1 Front Control Panel Header
JL1 Chassis Intrusion Header
JPCIE4 PCH SLOT4 PCIe 3.0 x2 (IN x4)
JPCIE5 CPU SLOT5 PCIe 4.0 x8 (Slot5 will run at PCIe 3.0 x8 when a Pentium processor is installed)
JPCIE6
CPU SLOT6 PCIe 4.0 x8 (IN x16) (Slot6 will run at PCIe 3.0 x8 when a Pentium processor is installed)
JPCIE7 CPU SLOT7 PCIe 4.0 x4 (IN x8) (SLOT7 will be disabled when a Pentium processor is installed)
JPWR1 24-pin ATX Main Power Connector (Required)
JPWR2 +12V 8-pin CPU Power Connector (Required)
JSD1/JSD2 SATA DOM Power Connector
JSTBY1 Standby Power Header (5V)
JIPMB1 4-pin external BMC I²C header (for an IPMI card)
JTPM1 Trusted Platform Module/Port 80 Connector
JUIDB1 UID Switch
LAN1/LAN2 Gigabit (RJ45) Ports
M.2-P, M.2 NVME M.2 PCIe 3.0 x4 Slot (supports 22110/2280 FF)
JPI²C1 Power SMB (System Management Bus) I²C Header
USB0/1 Back Panel USB 2.0 Ports
USB2/3 Front Accessible USB 2.0 Ports
USB4/5 Back Panel USB 3.2 Gen1 Connector
USB6/7 Front Accessible USB 3.2 Gen1 Ports via Headers
USB8 Front Accessible USB 3.2 Gen1 Port (Type-A)
VGA VGA Port
To Next Page
Loading...
