Supermicro X12STL-F - Page 51

51
Chapter 2: Installation
BMC
JPG1
JWD1
I-SGPIO1
I-SGPIO2
M.2-P
M.2 NVME
I-SATA4
I-SATA3
I-SATA2
MEGERAC
LICENCE
BT1
CPU SLOT6 PCIe 4.0 x8 (IN x16)
PCH SLOT4 PCIe 3.0 x2 (IN x4)
CPU SLOT5 PCIe 4.0 x8
JBT1
REV:1.01
X12STL-F
JUIDB1
LED1
LEDM1
JPCIE7
FAN4
COM2
USB2/3
JIPMB1
JPME2
JPWR2
JPWR1
JPI2C1
JF1
USB6/7 (3.0)
JL1
JSD2
JSD1 USB8(3.0)
LED4
LED3
JSTBY1
FAN1FAN2
FAN3
FANAFANB
I-SATA1
I-SATA0
JPCIE6
JPCIE5
JPCIE4
JPCIE5
MH10
MH11
JTPM1
CPU SLOT7 PCIe 4.0 x4 (IN x8)
DIMMB1 DIMMA2 DIMMB2 DIMMA1
USB0/1
BMC_LAN
COM1
VGA
LAN2
LAN1
USB4/5
I-SATA5
CHASSIS INTRUSION
PWRI2C
DESIGNED IN USA
M.2
CPU
2
1
1. Manufacturing Mode
2. VGA Enable/Disable
VGA Enable/Disable
Use jumper JPG1 to enable or disable the VGA port using the onboard graphics controller.
VGA Enable/Disable
Jumper Settings
Jumper Setting 
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
ME Manufacturing Mode
Close pins 2-3 of jumper JPME2 to bypass SPI ash security and force the system to operate
in the manufacturing mode, which will allow the user to ash the system rmware from a host
server for system setting modications. Refer to the table below for jumper settings.
Manufacturing Mode
Jumper Settings
Jumper Setting 
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode