Supermicro X12STL-F - Page 77

Chapter 4: BIOS
77


Super IO Chip: AST2600


Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This feature displays the base I/O port address and the Interrupt Request address of the
selected serial port.
Change Settings
This feature species the base I/O port address and the Interrupt Request address of Serial
Port 1. Select Auto to allow the BIOS to automatically assign the base I/O and IRQ address
to a serial port specied. The options are Auto, (IO=3F8h; IRQ=4;), (IO=2F8h; IRQ=4;),
(IO=3E8h; IRQ=4;), and (IO=2E8h; IRQ=4;).


Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled
Device Settings
This feature displays the base I/O port address and the Interrupt Request address of the
selected serial port.
Change Port Settings
This feature species the base I/O port address and the Interrupt Request address of Serial
Port 2. Select Auto to allow the BIOS to automatically assign the base I/O and IRQ address
to a serial port specied. The options are Auto, (IO=3F8h; IRQ=3;), (IO=2F8h; IRQ=3;),
(IO=3E8h; IRQ=3;), and (IO=2E8h; IRQ=3;).
Serial Port 2 Attribute
Select SOL to use COM Port 2 as a Serial Over LAN (SOL) port for console redirection.
The options are SOL and COM.