Supermicro X12STL-F - Page 82

Super X12STL-F User's Manual
82
Bits Per Second EMS
This feature sets the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 57600, and 115200 (bits per second).
Flow Control EMS
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xo󰀨.
Data Bits EMS: 8 Parity EMS: None Stop Bits EMS: 1

SATA Controller(s)
This feature enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Enabled and Disabled.
SATA Mode Selection
Select AHCI to congure an sSATA drive specied as an AHCI drive. Select RAID to congure
an sSATA drive specied as a RAID drive. The options are AHCI and Intel RSTe Premium
With Intel Optane System Acceleration.
*If the feature above is set to Intel RSTe Premium With Intel Optane System Acceleration,
the SATA Interrupt Selection is available for conguration:
SATA Interrupt Selection
Use this feature to select the interrupt that will be available to the operating system. The
options are MSI-x, MSI, and Legacy.
Aggressive LPM Support
When this feature is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
Serial ATA Port 0~7
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
Port 0-7 Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disabled and Enabled.