Supermicro X12STL-F - Page 95

Chapter 4: BIOS
95
When SEL is Full
This feature allows you to decide what the BIOS should do when the system event log is full.
Select Erase Immediately to erase all events in the log when the system event log is full. The
options are Do Nothing and Erase Immediately.
Note: All values changed here do not take e󰀨ect until the computer is restarted.



Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the feature above is set to Yes, Conguration Address Source, VLAN, and IPv6
Support are available for conguration:
Congure IPv4 Support
IPMI LAN Selection
Use this feature to select the type of the IPMI LAN. The default setting is Failover.
IPMI Network Link Status
This feature displays the status of the IPMI network link for this system. The default setting
is Dedicated LAN.

Use this feature to select the IP address source for this computer. If Static is selected,
you will need to know the IP address of this computer and enter it to the system manually
in the eld. If DHCP is selected, AMI BIOS will search for a Dynamic Host Conguration
Protocol (DHCP) server attached to the network and request the next available IP address
for this computer. The options are DHCP and Static.
*If the feature above is set to Static, the following features are available for
conguration:
Station IP Address: This feature displays the Station IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 172.29.176.131).
Subnet Mask: This feature displays the sub-network that this computer belongs to. The
value of each three-digit number separated by dots should not exceed 255.
Station MAC Address: This feature displays the Station MAC address for this computer.
Mac addresses are six two-digit hexadecimal numbers.
Gateway IP Address: This feature displays the Gateway IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 172.29.0.1).
VLAN: This feature displays the status of VLAN support. The default setting is Disable.