Supermicro X13SAE - Page 121

Chapter 4: UEFI BIOS
121
Password Policy
Use this feature to set the password policy. The options are Default Password Only,
During Setup and Conguration, and Anytime.
• Default Password: If the default password has not been changed yet, the Intel MEBx
password can be changed via the network interface.
• During Setup and Conguration: The Intel MEBx password can only be changed
during setup. Once the setup and conguration process is nished, it can no longer be
changed through the network interface.
• Anytime: The Intel MEBx password can be changed via the network interface anytime.
Network Setup
Intel(R) ME Network Name Settings.
FQDN
Press <Enter> to set the machine's host name and domain name.
• Host Name: This will be the host name of the machine. The host name can be
followed by the following characters (ex. letter, digit, pound sign, underscore, or
hyphen), and end with a letter or digit. The length is no longer than 63 characters.
• Domain Name: A domain name where the machine belongs to. The domain name
must begin and end with a letter or digit. The Inner characters might be letters,
digits, or hyphens. The length is no longer than 191 characters.
Shared/Dedicated FQDN
This feature determines if the Fully Qualied Domain Name (FQDN) is shared with
the host and the same as the operating system machine or is unique to the Intel
ME. The options are Dedicated and Shared.
Dynamic DNS Update
This feature will enable Intel ME to actively try to register its IP addresses and
FQDN in DNS using the Dynamic DNS Update protocol. The options are Disabled
and Enabled.