Appendix A: BIOS Codes
125
Appendix A
BIOS Codes
A.1 BIOS Error POST (Beep) Codes
During the Power-On Self-Test (POST) routines, which are performed each time the system
is powered on, errors may occur.
Non-fatal errors are those which, in most cases, allow the system to continue the boot up
process. The error messages normally appear on the screen.
Fatal errors are those which will not allow the system to continue the boot up process. If
a fatal error occurs, you should consult with your system manufacturer for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The table
shown below lists some common errors and their corresponding beep codes encountered
by users.
BIOS Beep (POST) Codes
Beep Code Error Message Description
1 beep Refresh Circuits have been reset (Ready to power up)
5 short, 1 long Memory error No memory detected in system
5 long, 2 short Display memory read/write error Video adapter missing or with faulty memory
1 long continuous System OH System overheat condition
To Next Page
Loading...
