Supermicro X13SAE - 2.4 Memory Support and Installation

34
Super X13SAE/X13SAE-F User's Manual
2.4 Memory Support and Installation
Note: Check the Supermicro website for recommended memory modules.
Important: Exercise extreme care when installing or removing DIMM modules to pre-
vent any possible damage.
General Guidelines for Optimizing Memory Performance
• When installing memory modules, the DIMM slots should be populated in the following
order: DIMMA2, DIMMB2, then DIMMA1, DIMMB1.
• Only populate DIMMA1 and DIMMB1 if the extra memory support is needed.
• To optimize memory performance, please use memory of the same type, size, and speed
on the motherboard.
• Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed of slowest
DIMM.
• The motherboard supports odd-numbered modules (one or three modules installed).
However, to achieve the best memory performance, a balanced memory population is
recommended.
DIMMA1
DIMMA2
DIMMB1
DIMMB2
USB11 (3.2 (20Gb))
USB4/5 (3.2 (5Gb))
USB6 (3.2 (5Gb))
LED4
BMC_HB_LED
UID
DP
HDMI
VGA
DVI
IPMI_LAN
USB0/1
LAN1
USB7 (3.2 (10Gb))
USB10 (3.2 (20Gb))
LAN2
USB8/9 (3.2 (10Gb))
JPL2
JPAC1
PCI-E M.2-M2
PCI-E M.2-M3
PCI-E M.2-M1
JPW1
CPU SLOT7 PCI-E 5.0 X16 CPU SLOT4 PCI-E 5.0 X8 (IN x16) PCH SLOT5 PCI-E 3.0 X4 PCH SLOT2 PCI-E 3.0 X4
SLOT1 PCI 33MHZ
BMC
BT1
MAC CODE
BMC CODE
BAR CODE
MAC CODE
BIOS LICENSE
X13SAE-F
DESIGNED IN USA
REV:1.00
JPME2
JLED1
JD1
JPG1
I-SATA0
I-SATA1
I-SATA2
I-SATA3
I-SATA4
I-SATA5
I-SATA6
I-SATA7
JWD1
PWR_LED
CATERR_LED
JSTBY1
JL1
JSD1
SYS_FAN3
SYS_FAN2
SYS_FAN1
CPU_FAN2
CPU_FAN1
JPW2
12V_PUMP_PWR1
AUDIO_FP
COM1
USB2/3
JTPM1
SP1
JF1
JBT1
JPI2C1
PCH
AUDIO
JPL1
DIMMA1
DIMMA2
DIMMB1
DIMMB2