35
Chapter 2: Installation
DIMM Installation
1. Insert DIMM modules in the following order:
DIMMA2, DIMMB2, then DIMMA1, DIMMB1.
For the system to work properly, use memory
modules of the same type and speed.
2. Align the DIMM module key with the receptive
point on the single-latch DIMM slot.
3. Push the release tab outwards to unlock the
slot.
4. Press both ends of the module straight down
into the slot until the module snaps into place.
5. Push the release tab to the lock position to
secure the module into the slot.
DIMM Removal
Reverse the steps above to remove the DIMM
modules from the motherboard.
Receptive Point
Release Tab
Notch
Push both ends straight
down into the memory slot.
To Next Page
Loading...
