Supermicro X13SAE - 2.5 M.2 Installation

36
Super X13SAE/X13SAE-F User's Manual
DIMMA1
DIMMA2
DIMMB1
DIMMB2
BMC
BIOS LICENSE
X13SAE-F
DESIGNED IN USA
REV:1.00
PCH
2.5 M.2 Installation
This motherboard has three PCIe 4.0 M.2 M-key
sockets that support the M.2 2280 module. One
stando󰀨 is pre-installed into the position of 2280
mounting hole. Refer to the illustration on the right
for the locations of M.2 sockets and mounting
holes. Follow the steps below to install the M.2
device.
1. Locate the pre-installed stando󰀨. Remove the
stando󰀨 screw and set it aside.
2. Carefully insert the M.2 device into the M.2
socket and lower the semi-circle notched end
onto the stando󰀨.
3. Tighten the stando󰀨 screw to secure the M.2
device into place. Do not overtighten so as to
avoid damaging the M.2 device.
2280
2280
2280