Supermicro X13SAE - Page 123

Chapter 4: UEFI BIOS
123
• FQDN
• Serial Number
• Time Validity Pass
Note: If the feature shows "Provision Record is not present", it means there is no
data entered.
Provisioning Server address
Press <Enter> to set the provisioning server address. It could be either host name,
IPv4, or IPv6 address.
Provisioning server port number
Press <Enter> to set the provisioning server port number. The value should be between
0 and 65535. The default is 9971.
Remote Conguration
Use this feature to enable or disable the remote conguration. The options are Dis-
abled and Enabled.
*If the feature above is set to Enabled, the following features will become avail-
able for conguration:
PKI DNS Su󰀩x
Press <Enter> to set a value for the PKI DNS Su󰀩x.
Manage Certicates
Use this feature to enumerate the hashes in the system. Select the desired hash item
using the arrow key to display the Hash Name, the active state, and the default state.
Stop Remote Conguration
Press <Enter> to swap between Stop Remote Conguration and Active Remote Con-
guration. The default is Active Remote Conguration.
Power Control
These congurations are e󰀨ective only after ME provisioning has started.
ME ON is Host Sleep States
Use this feature to set a desired power package. The options are Desktop: ON in S0
and Desktop: ON in S0, ME Wake in S3, S4-5.