Supermicro X13SAE - Page 53

53
Chapter 2: Installation
Front Panel Audio Header
A 10-pin Audio header (AUDIO_FP) is supported on the motherboard. This header allows
you to connect the motherboard to a front panel audio control panel, if needed. Connect an
audio cable to the audio header to use this feature (not supplied). Refer to the table below
for pin denitions.
Front Panel Audio Header
Pin Denitions
Pin# Denition Pin# Denition
1 Microphone_Left 6 Ground
2 Audio_Ground 7 Jack_Detect
3 Microphone_Right 8 Key
4 Audio_Detect 9 Line_2_Left
5 Line_2_Right 10 Ground
Internal Speaker/Buzzer
The Internal Speaker/Buzzer (SP1) is used to provide audible indications for various beep
codes. Refer to the table below for pin denitions.
Internal Buzzer
Pin Denitions
Pin# Denition
1 Pos (+) Beep In
2 Neg (-) Alarm Speaker
1. Front Panel Audio Header
2. Internal Speaker/Buzzer
DIMMA1
DIMMA2
DIMMB1
DIMMB2
USB11 (3.2 (20Gb))
USB4/5 (3.2 (5Gb))
USB6 (3.2 (5Gb))
LED4
BMC_HB_LED
UID
DP
HDMI
VGA
DVI
IPMI_LAN
USB0/1
LAN1
USB7 (3.2 (10Gb))
USB10 (3.2 (20Gb))
LAN2
USB8/9 (3.2 (10Gb))
JPL2
JPAC1
PCI-E M.2-M2
PCI-E M.2-M3
PCI-E M.2-M1
JPW1
CPU SLOT7 PCI-E 5.0 X16 CPU SLOT4 PCI-E 5.0 X8 (IN x16) PCH SLOT5 PCI-E 3.0 X4 PCH SLOT2 PCI-E 3.0 X4
SLOT1 PCI 33MHZ
BMC
BT1
MAC CODE
BMC CODE
BAR CODE
MAC CODE
BIOS LICENSE
X13SAE-F
DESIGNED IN USA
REV:1.00
JPME2
JLED1
JD1
JPG1
I-SATA0
I-SATA1
I-SATA2
I-SATA3
I-SATA4
I-SATA5
I-SATA6
I-SATA7
JWD1
PWR_LED
CATERR_LED
JSTBY1
JL1
JSD1
SYS_FAN3
SYS_FAN2
SYS_FAN1
CPU_FAN2
CPU_FAN1
JPW2
12V_PUMP_PWR1
AUDIO_FP
COM1
USB2/3
JTPM1
SP1
JF1
JBT1
JPI2C1
PCH
AUDIO
JPL1
1
2