Supermicro X13SAE - Page 87

Chapter 4: UEFI BIOS
87
NCT6796DE Super IO Conguration
NCT6796DE Super IO Conguration
• Super IO Chip - NCT6796DE
Serial Port 1 Conguration
Serial Port 1 Conguration
Serial Port 1
This feature will Enable or Disable Serial Port (COM1). Check the box to enable Serial
Port. The default is Enabled.
Device Settings - IO=3F8h; IRQ=4;
Change Settings
This feature congures the IRQ setting for Serial Port 1 (COM1). The default is Auto.
Network Conguration
Network Stack
Select Enabled to enable Unied Extensible Firmware Interface (UEFI) for network stack
support. The options are Disabled and Enabled.
*If this feature is set to enabled, the following features will become available for
conguration:
IPv4 PXE Support
Select Enabled to enable IPv4 Preboot Execution Environment (PXE) for boot support. If
this feature is set to Disabled, IPv4 PXE boot option will not be supported. The options are
Disabled and Enabled.
IPv4 HTTP Support
Use this feature to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 Preboot Execution Environment (PXE) for boot support. If
this feature is set to Disabled, IPv6 PXE boot option will not be supported. The options are
Disabled and Enabled.
IPv6 HTTP Support
Use this feature to enable IPv6 HTTP boot support. The options are Disabled and Enabled.