Supermicro X13SAE - Page 97

Chapter 4: UEFI BIOS
97
*If the feature above is set to Enabled, the following features will become available
for conguration:
Console Redirection Settings
Out-of-Band Mgmt Port
This feature selects a serial port in a client server to be used by the Microsoft Windows
Emergency Management Services (EMS) to communicate with a remote host server. The
options are COM1, SOL, and AMT SOL.
Terminal Type
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to
use UTF8 encoding to map Unicode characters into one or more bytes. The options are
VT100, VT100Plus, VT-UTF8, and ANSI.
Bits Per Second
This feature sets the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer.
A lower transmission speed may be required for long and busy lines. The options are
9600, 19200, 57600, and 115200 (bits per second).
Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xo󰀨.
The setting for each of these features is displayed:
• Data Bits
• Parity
• Stop Bits
USB Conguration
USB Conguration
The following information will be displayed:
• USB Module Version