Supermicro X13SWA-TF - Page 103

Chapter 4: UEFI BIOS
103
PCH-FW Conguration
The following rmware information will display:
• ME Firmware Mode
• ME Firmware SKU
ME FW Image Re-Flash
Use this feature to update the Management Engine rmware. The options are Enabled and
Disabled.
PTT Conguration
PTT Capability / State
This features displays the information of Intel Platform Trust Technology (PTT) capability
and state.
TPM Device Selection
Use this feature to select the type of TPM device. Select Intel Platform Trust Technology
(PTT) to enable PTT in SkuMgr. Selecting dTPM will disable PTT in SkuMgr. The options
are dTPM and PTT. (Warning! PTT/dTPM will be disabled and all saved data will be lost.)
SATA and RST Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following features.
SATA Conguration
This feature enables or disables the onboard SATA controller(s) supported by the Intel PCH
chip. The options are Disabled and Enabled.
SATA Mode Selection (Available when "SATA Conguration" is set to Enabled)
Use this feature to select the mode of installed SATA drives. The options are AHCI and RAID.
Note 1: After changing the SATA mode, please be sure to reboot the system for the
changes to take e󰀨ect. Then the Intel(R) VROC SATA Controller feature will appear
under the Advanced menu.
Note 2: To create RAID for the SATA drives, refer to the Intel(R) VROC SATA Control-
ler section for more information.