38
Super X13SWA-TF User's Manual
2.5 M.2 Installation
This motherboard has four M.2 M-key sockets that
support the 2280 and 22110 M.2 devices. One
stando is pre-installed into the position of each 22110
mounting hole. Refer to the illustration on the right
for the locations of M.2 sockets and mounting holes.
Follow the steps below to install the M.2 device.
Note 1: Please use wide temperature (up to 85°C)
M.2 devices for M.2-C4 and M.2-C3.
Note 2: It is strongly recommended that you install an optional Supermicro M.2 heatsink
(p/n SNK-C0156L) on the M.2 device.
22110
22110
2280
2280
M.2 Heatsink Installation (Optional)
1. Remove the thermal pad protective lms
from the cover and the tray of the M.2
heatsink.
2. Place the M.2 device into the tray, then put the heatsink cover in place. Be careful to
align the holes on the tray with the holes on the cover.
3. Tighten the screws to secure the heatsink
assembly.
Heatsink Cover
Heatsink Tray
To Next Page
Loading...
