40
Super X13SWA-TF User's Manual
22110 M.2 Device Installation
1. Locate the pre-installed stando. Remove the
stando screw and set it aside.
2. Insert the M.2 device or the heatsink assembly into the M.2 socket at a 30-degree angle
and press it down.
3. Tighten the stando screw to secure the M.2 device or the heatsink assembly into place.
Do not overtighten so as to avoid damaging the M.2 device.
Standard M.2 device
M.2 device with Supermicro heatsink
Standard M.2 device
M.2 device with Supermicro heatsink
To Next Page
Loading...
