Supermicro X9QR7-TF+ - Page 13

Chapter 1: Overview
1-5
X9QR7-TF+/X9QRi-F+ Jumpers
Jumper
Description Default Setting
JBT1 Clear CMOS See Chapter 2
JPB1 BMC Enabled Pins 1-2 (Enabled)
JPG1 VGA Enabled Pins 1-2 (Enabled)
JPME1 Management Engine (ME)
Recovery Mode
Pins 1-2 (Normal)
JPME2 Management Engine (ME)
Manufacture Mode
Pins 1-2 (Normal)
JPRST1 BMC Reset Off (Normal)
JPS1 SAS Enable Pins 1-2 (Enabled)
JPT1 TPM (Trusted Platform) Enable Pins 1-2 (Enabled)
JPTG1 GLAN1/GLAN2 Enable Pins 1-2 (Enabled)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset)
X9QR7-TF+/X9QRi-F+ Connectors
Connectors Description
BT1H1 Onboard Battery (For Proper Battery Disposal, Refer to Chpt.3)
COM1/COM2 Backplane COM Port1/Front Accessible COM2 Header
FAN1~10 CPU/System Fan Headers
I-SATA 0/1 Intel SB SATA 3.0 Connectors 0/1 (Color: White)
I-SATA 2~5 Intel SB SATA 2.0 Connectors 2~5 (Color: Black)
JIPMB1 4-pin External BMC I
2
C Header (for an IPMI Card)
JD1 Speaker/Power LED Indicator
JF1 Front Panel Control Header
JL1 Chassis Intrusion
JOH1 Overheat LED Indicator
JPI
2
C1 Power Supply SMBbus I
2
C Header
JPW1 ATX 24-Pin Power Connector (See Warning on Pg. 1-6.)
JPW2~5 12V 8-Pin Power Connectors (See Warning on Pg. 1-6.)
JSD1 SATA DOM (Device on Module) Device Power Connector
LAN1/LAN2 G-bit Ethernet Ports 1/2
LS2E1 Internal Speaker (Buzzer)
(IPMI) LAN IPMI_Dedicated LAN
SAS0~3, 4~7 SAS (Serial Attached SCSI) Connections 0~3, 4~7 (JS1/2) (for
X9QR7-TF+ only)
(CPU4)Slot1/
(CPU1) Slot3
PCI-Express 3.0 x8 in x16 Slots