Chapter 4: AMI BIOS
4-23
Caution: Make sure that you no longer need any data stored in the event
log before clearing the BMC Event Log because you will not be able to
recover any data included in the event log once you've "cleared" it.
Set LAN Confi guration
Set this feature to confi gure the IPMI LAN adapter with a network address as shown
in the following graphics.
Channel Number-This item displays the channel number of current LAN connec-
tion.
Channel Number Status - This feature displays the channel status for the channel
number indicated above.
IP Address Source
Use this item to select the source of this machine's IP address. If Static is selected,
you will need to know the IP address of this machine and enter it to the system
manually in the fi eld. If DHCP is selected, the BIOS will search for a DHCP (Dynamic
Host Confi guration Protocol) server in the network it is attached to and request the
next available IP address. The options are DHCP and Static. The following items
are assigned IP addresses automatically if DHCP is selected:
IP Address
Use this item to select the IP address for this machine. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253). The value of each three-digit number
separated by dots should not exceed 255 as shown in the screen below.
Subnet Mask
This feature shows the network which subnet this machine belongs to. The value
of each three-digit number separated by dots should not exceed 255.
Gateway Address
This is the IP address of the gateway in the network. This is usually a router.
Mac Address
The BIOS will automatically enter the Mac address of this machine; however it may
be overwritten. Mac addresses are 6 two-digit hexadecimal numbers (Base 16, 0 ~
9, A, B, C, D, E, F) separated by dots. (i.e., 00.30.48.D0.D4.60).
Event Log Confi guration
View Event Log
Use this option to view the System Event Log.
To Next Page
Loading...
Need help?
General
