17
Erasing all the paired devices and all the phonebooks:
The SUPERTOOTH HD-L must be set to pairing mode (from off, press
and hold the On / Off button (7) until the Bluetooth indicator (2) turns
blinking red/blue. The kit is now on pairing mode.)
Once your kit is on pairing mode ignore the vocal procedure and
press and hold the End / Reject button and Phonebook update (8) for
5 seconds until a distinctive melody is heard on the kit. Now, all the
paired phones and the phonebook are erased. You can proceed to
a new pairing following the ongoing procedure or referring to section
5. Selecting language and pairing to your mobile phone.
Easy Pairing:
The easy pairing is a pairing procedure, which allows you to pair your
phone to the handsfree kit without executing any Bluetooth search
from your phone.
IMPORTANT: Make sure that your phone’s Bluetooth mode is active
and discoverable (see your phone’s manual). Then place your phone
and the SUPERTOOTH HD-L close to each other.
The SUPERTOOTH HD-L must be set to pairing mode (from off, press
and hold the On / Off button (7) until the Bluetooth indicator (2) turns
blinking red/blue. The kit is now on pairing mode.)
Once your kit is on pairing mode the kit will say, “Press Volume Control
(1) to select British English.” The SUPERTOOTH HD-L will cycle through all
available languages. Short press the Volume Control button (3) when
you hear your language.
Once your preferred language is selected, ignore the vocal
procedure and directly short press the Volume Control button (1). The
kit will say, “Easy Pairing” and will process your phone research (beeps
will be heard). Accept any connection request on your phone. Enter
the pin code “0000” if requested.
For the next steps, please refer to section 5 at 3. Automatic
Phonebook Transfer.
To Next Page
Loading...
