2023-11-30 33 2301122
Ballast and Pitch & Roll Set Points
Touch the Advanced button and the following image will appear:
Note: The engine must be running to fill the ballast.
When AutoWake is off adjust the Ballast settings by the up
and down arrows.
Touch to fill all three ballasts at one time.
Touch to drain all three ballasts at one time. If the
engine is not running, the manual override will be enabled
and the following screen will appear while the ballasts are
draining.
Turn off the draining of the ballast by touching .
While the ballast is filling or draining, arrows will
appear on screen to depict the direction and where to
shift the existing weight to compensate for the lost
ballast weight.
Save the new ballast settings by touching or discard the changes by
touching .
To Next Page
Loading...
