BRINE CABINET
STEP 1. Add water conditioner salt to the brine cabinet.
STEP 1. Plug the transformers output lead into the socket
on the appliances power cord; secure it by means of the
TwistLock clamp.
STEP 2. Plug the transformer into an electrical outlet.
ELECTRICAL
STEP 6. After 2-3 minutes, open a cold treated water
faucet nearby the appliance and let the water run for a few
minutes until all air is purged from the installation and the
resin bed is rinsed (it is normal for the rinse water to show
some discoloration!); close the tap.
STEP 7. Check the appliance and all hydraulic connections
for leaks.
After the first regenerations of the appliance, some slight
discoloration of the treated water might occur. This is
totally harmless and will disappear rapidly!
STEP 1. Make sure the bypass system is in 'bypass'
position.
STEP 2. Make sure the electronic controller of the
appliance is in service mode.
STEP 3. Open the mains water supply.
STEP 4. Open a cold treated water faucet nearby the
appliance and let the water run for a few minutes until all
air is purged and all foreign material that may have
resulted from the installation is washed out; close the tap.
STEP 5. Gently pressurize the appliance, by putting it into
service:
factory bypass:
1. open the 'outlet' valve;
2. slowly open the 'inlet' valve.
3-valve bypass:
1. close the 'bypass' valve;
2. open the 'outlet' valve;
3. slowly open the 'inlet' valve.
PRESSURIZING
8
COMMISSIONING
ELECTRONIC CONTROL PANEL
STEP 1. Program the electronic controller.
PERFORM REGENERATION
STEP 1. Manually initiate a regeneration, by pressing the
scroll button; the display will show:
R egen in 10 sec
STEP 2. Leave the appliance in this position; the
countdown timer will countdown to 0 sec and start
a regeneration.
NOTE!
Fill the brine tank with salt up to 3/4 of its volume, then fill
the tank with water up to 1/2 of its volume (fill the tank
manually), wait approx. 6 hours until formation of brine
solution.
To Next Page
Loading...
Need help?
General
