EasyManua.ls Logo

SUR-RON STORM BEE E - Battery Pack Installation; Installing Battery Pack; Check Before Riding

Default Icon
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery pack installation
1.Put the battery pack in the battery compartment
2.Press the the front compression bracket ○C of the battery pack and the rear compression
bracket ○B of the battery pack to the fixed lugs
3.plug the battery pack discharge plug ○E back in first, then plug the charging plug ○D next
4.Install the seat back in according to the arrow showing on the diagram, first put the the seat
on the frame and push the seat backward along the arrow direction to fix the seat hook on the
subframe.
5. Use a portable tool to install the two mounting screws of the front support cover of the seat
○A
Warning: Before removal and installation of the battery pack on the electric motorcycle, the key
switch must be in the OFF position, so that the whole motorcycle is in no power condition
Warning: Do not change the installation steps of the charging plug and the discharge plug at
will. As the battery pack are high-voltage components, the wrong installation steps may cause
serious injury.
Starting and Operating
4.1
Check before riding
Before operating the electric motorcycle, please check the following item to ensure that the
electric motorcycle is in operational condition
Battery pack
Check that the battery level displayed on the battery pack or dashboard is sufficient to support
your riding. We recommend you to full charge before use
Chain
Check the chain tension and condition. Adjust or replace if necessary. See "Chain" on page 10.9
Brake system
Pull the brake lever and push the motorcycle to see if the front and rear wheels are locked. You
should be able to lock the wheels completely by braking
Throttle
When the key switch is in the off position, twist the throttle and release it to check whether the
throttle is move smoothly and return to idle freely.
Tyre
Check the tire pressure and tread depth of the tires.
Check the cold tire pressure, maintain the correct tire pressure, and check for damage and
abnormal wear of the tire. As described on page 10.8, when the tread depth is less than 2 mm,
please replace the tire immediately.
Warning! Unusual tire pressure is a common reason that cause of tire failure, and may cause
severe tires issues or loss the control of the electric motorcycle, which may result in serious
personal injury. Check the tires regularly to ensure proper tire condition.
Electrical System

Related product manuals