• In Phase 1, when riding the electric motorcycle, the temperature indicator progress bar will
gradually increase until the entire temperature indicator ○B flashes, and the orange system
warning indicator ○A above the dashboard will also start flashing, and tell you the Storm electric
motorcycle is about to enter the temperature protection mode. To prevent the motorcycle from
forced reducing its power, you can choose to slow down and riding smoothly or switch to ECO
mode until the indicator light stops flashing.
•Phase 2 If the temperature continues to rise, the orange system warning indicator ○A above
the dashboard will stay on to inform you that the electric motorcycle is now enter a
temperature protection strategy, and the power of the Storm Bee electric motorcycle will be
reduced accordingly.
Starting and Operating
4.6
ABS（Anti-lock braking system）
Warning! The ABS anti-lock braking system maximizes the braking efficiency in emergency
situations and the safety during riding. Under certain conditions, ABS can shorten the braking
distance, but it cannot replace good riding habits.
Warning! Please ride safely and respect the legal speed limit on the road.
Warning! Ride cautiously when turning. If you braking while turning, ABS may not be able to
offset the centrifugal force of inertia. Such activities will cause unsafe riding and easily cause
accidents. Certain riding conditions and environments may reduce the braking efficiency of ABS
and make its braking distance equal to that of a motorcycle without ABS.
1、 ABS Switching ON/OFF conditions
① The whole motorcycle is powered on；
② The speed of the front and rear wheels of the motorcycle is zero；
③ The electric motorcycle is in non-diagnostic mode。
ABS operation method
① After turn the Key switched ON, ABS is turned on by default；
② When the ABS is in the OFF condition, the ABS indicator flashes at a frequency of 1.2 second,
when the ABS is in the ON condition, the ABS indicator is off；
③ When the ABS switch is pressed for more than 3s and not released within 5s, the ABS ON/OFF
switch request will be ignored and the ABS keeps the current state；
④ When the ABS switch is pressed for more than 30s, the ECU of the ABS regards the switch
signal as a fault signal, and the ABS returns to default ON state. The ABS can only be turned
OFF after the power is switched on again.
4.7
Disable ABS
1. In the parking state, put down the sidestand；
To Next Page
Loading...
