To quickly get started with the programming of WONDOM APM2 or JAB3 via ICP3, do the
following steps:
1) Install the SigmaStuido software
2) Connect ICP3 to computer
3) Connect audio cables of APM2/JAB3
4) Power up the audio system
5) Connect ICP3 with APM2/JAB3
6) Program
Quick Start
Click HERE to watch video.
Since the most steps of programming APM2 and JAB3 are the same, we will take APM2 as an example to
show you how to operate. If there is difference or points to note, we wil mark out with red words.
To Next Page
Loading...
