Sure Electronics Wondom ICP3 - Trouble Shooting (Programming); ICP3 Recognition Issues; Programming Failures; Operational Issues

TROUBLE SHOOTING
TROUBLE HOW TO SOLVE
ICP3
cannot be recognized by PC
➢
Make sure the Micro USB cable is of good quality and supports data
communication
➢
Make sure ICP3 is not connected to controlled device (APM2) when
connected to PC
Cannot
writing the program into APM2 successfully
➢
Make sure the ICP3 be recognized by PC
➢
Make sure the SW of ICP3 is at  (PROGRAM) and the SW1 on APM2
is set at  (RUN)
Cannot
writing the program into JAB3 successfully
➢
Make sure JAB3 is given audio signal and the two LEDs are on
➢
Make sure the ICP3 be recognized by PC
➢
Make sure the SW of ICP3 is at  (PROGRAM)
APM2 / JAB3 cannot
work normally (cannot play music) under powering
condition when connected with ICP3
➢
Make sure the connection steps are correct and check the
input/output cables
➢
Disconnect with ICP3 and re-power APM2
➢
Make sure the SW1 on APM2 is set at  (RUN)
(Not applicable to JAB3)