Need help?Do you have a question about the Sure Electronics Wondom ICP3 and is the answer not in the manual?
General| Model | ICP3 |
|---|---|
| Manufacturer | Sure Electronics Wondom |
| Interface | USB |
| LAN | 10/100 Ethernet |
| Operating Temperature | 60°C |
Provides instructions and a direct link for downloading and installing the SigmaStudio software.
Steps for setting the ICP3 switch, connecting to PC via USB, and verifying recognition.
Instructions for powering the APM2 DSP Kernel Board and the APM3 Extension Kit.
Steps to compile the project and establish a connection between ICP3 and the computer.
Instructions for writing the compiled program to the E2PROM using SigmaStudio.
Instructions on writing the selected firmware file to the E2PROM and confirming the operation.
Solutions for common problems where the ICP3 is not recognized by the PC.
Guidance for resolving issues when programming APM2 or JAB3 fails.
Troubleshooting steps for when APM2/JAB3 does not work normally after powering up.
Details the pin-to-pin connection using a 6-pin cable via the programming port.
Instructions to set the ICP3 SW to 'REMOTE' mode before running the 'Miumax' APP.
Steps for enabling device Bluetooth, launching the APP, and achieving successful pairing.
Guidance for resolving problems with APP control, including app relaunch and button management.
To Next Page
