14
3. Using Configuration Menu
The Realtek Remote Control Protocol (RRCP) is a simple control protocol proposed to
enhance the functionalities of this Layer 2 switches by software. The RRCP Management
Application, is a Window-based software package that implements RRCP functions at the
management host side. The RRCP Management Application gives network administrators the
ability to configure and monitor switches like intelligent switches.
Before you getting started, make sure that you meet the following requirements.
1. A computer with an Ethernet network card installed and CD-ROM Drive
2. This CD-ROM with RRCP program
3. Your Windows CD, if your computer is running Windows 98,XP,2000,NT4.0,Service Pack 6
or ME
4. UTP network cable with RJ-45 connector
3.1 Software Installation
WinPcap 3.0 Installation
1. Insert the attached CD-ROM with this switch into PC’s CD-ROM drive.
2 .Select the “WinPcap 3.0” and click “Install”. Then follow the install wizard to finish
installation.
RRCP Installation
1.On the main screen, select “RRCP” and click “Install”. Then follow the install wizard to finish
installation.
2.After installation, there will be a “RRCP Icon” on the desktop.
3.2 Using RRCP
1. Double click the RRCP’s icon or select the “RMT” in the start program menu.
To Next Page
Loading...
Need help?
General
