YH4
GRAND
VITARA
1. Battery
2. Positive cable
3. Negative cable
4. Body ground bolt
5. Retainer
6. Nut
6H-12 CHARGING SYSTEM
WITH CHARGING EQUIPMENT
CAUTION:
When jump starting engine with charging equipment, be
sure equipment used is 12-volt and negative ground. Do not
use 24-volt charging equipment. Using such equipment can
cause serious damage to electrical system or electronic
parts.
DISMOUNTING
1) Disconnect negative cable.
2) Disconnect positive cable.
3) Remove retainer.
4) Remove battery.
HANDLING
When handling battery, following safety precautions should be fol-
lowed:
Hydrogen gas is produced by battery. A flame or spark near bat-
tery may cause the gas to ignite.
Battery fluid is highly acidic. Avoid spilling on clothing or other fab-
ric. Any spilled electrolyte should be flushed with large quantity
of water and cleaned immediately.
REMOUNTING
1) Reverse removal procedure.
2) Torque battery cables to specification.
NOTE:
Check to be sure that ground cable has enough clearance
to hood panel by terminal.
Tightening Torque
(a): 8.0 N
.
m (0.8 kg-m, 6.0 lb-ft)
To Next Page
Loading...
Need help?
General
