Suzuki 2006 GSF1200AK6 - Page 61

60 GSF1200AK6/SAK6 (’06-MODEL)
Step 4
1) Measure the resistance between

B (White) and ground at
the rear wheel speed sensor coupler.
% Normal value: ∞ Ω (Infinity)
Is the resistance between

B and ground OK?
Step 5
1) Check for continuity between

2 (B/Y) on the ABS control unit
coupler and

C (B/Y) on the rear wheel speed sensor coupler.
% Normal value: Continuity ())
( Tester knob indication: Continuity test ())
Is there continuity between

2 and

C?
Step 6
1) Check the continuity between

H (W/Y) on the ABS control
unit coupler and

D (W/Y) on the rear wheel speed sensor
coupler.
% Normal value: Continuity ())
( Tester knob indication: Continuity test ())
Is there continuity between

H and

D?
Step 7
1) Connect the rear wheel speed sensor coupler.
2) Connect three 1.5 V dry cells

A in series as shown and make
sure that their total voltage is more than 4.5 V.
Measure the current between

+ dry cell terminal and

2 (B/
Y) on the ABS control unit coupler.
% Normal value: 3 – 14 mA
" 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
+ Tester knob indication: Current (', 20 mA)
Is the current OK?
YES Inspect the wire harness. (Faulty W/Y wire)
NO Replace the rear wheel speed sensor.
Sensor side
YES Go to step 6.
NO Inspect the wire harness. (Faulty B/Y wire)
YES Go to step 7.
NO Inspect the wire harness. (Faulty W/Y wire)
YES Replace the ABS control unit/HU.
NO Replace the rear wheel speed sensor.
]
ABS control unit coupler (Harness end)
Harness
side
]
ABS control unit coupler (Harness end)
Harness
side
DCmA
ABS control unit coupler (Harness end)
SAMPLE