76 GSF1200AK6/SAK6 (’06-MODEL)
WIRE HARNESS, HOSE ROUTING AND SENSOR INSTALLATION
WIRE HARNESS ROUTING
*1 Cut the tip of wire clamp after clamping. *5
Pass through the lead wire between No.3 and
No.4 carburetors.
*2 Set the plug cap forward. *6
Pass through the battery
- lead wire inside of
the brake hose.
*3 Don’t pull this lead wire. *7
Pass through the harness between the hose
and frame.
*4 Tip of wire clamp backward. *8
Be careful not to pinch the wiring harness
between fender and frame.
Handle switch
harness
*1
Starter cable
*2
Starter
cable
Throttle
cables
Starter
cable
Thermo switch
(E-02, 19)
*3
Clamp
PAIR hose
Clamp
Frame
ABS pipe
Frame
Clamp
*4
Thermo switch
(E-02, 19)
Clamp
*6
*7
*8
Wiring
harness
ABS pipe
Brake switch
lead wire
Battery
lead wire
FWD
Handlebar switch (LH and RH)
Ignition switch
Front ABS sensor
Clamp
Carburetor heater
(E-02, 19)
*5
SAMPLE
To Next Page
Loading...
