66 GSF1200AK6/SAK6 (’06-MODEL)
DTC “61” (C1661): ABS solenoid malfunction
Step 1
1) Turn the ignition switch to OFF.
2) Remove the fuse box mounting bolt. (!Page 28)
3) Open the fuse box and inspect the ABS fuse
1.
ABS fuse: 15 A
Is the ABS fuse OK?
$
Step 2
1) Check the ABS control unit coupler for loose or poor con-
tacts. If OK, then disconnect the ABS control unit coupler.
2) Measure the voltage between
8 (R/Bl) and
N (B/W) at the
coupler.
% Normal value: Battery voltage (12.0 V and more)
" 09900-25008: Multi-circuit tester set
& Tester knob indication: Voltage (' )
Is the voltage between
8 and
N normal?
POSSIBLE CAUSE
Faulty solenoid valve or relay
YES Go to step 2.
NO Replace the ABS fuse.
If a fuse is blown, find the cause of the problem and
correct it before replacing the fuse.
YES Replace the ABS control unit/HU.
NO
Inspect the wire harness. (Faulty solenoid or
ground wire)
ABS control unit coupler (Harness end)
SAMPLE
To Next Page
Loading...
