LT-R450/ZK9 (’09-MODEL) 13
3) Check the IAP sensor coupler for loose or poor contacts.
If OK, then measure the IAP sensor input voltage.
4) Disconnect the IAP sensor coupler.
5) Turn the ignition switch ON.
6) Measure the voltage at the Red wire and ground.
7) If OK, then measure the voltage at the Red wire and B/Br
wire.
IAP sensor input voltage: 4.5 – 5.5 V
(+ Red – - Ground)
(+ Red – - B/Br)
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Voltage ()
Is the voltage OK?
Step 1 (When indicating P0105-H:)
1) Turn the ignition switch OFF.
2) Remove the engine mounting left upper bracket 1 by remov-
ing the bolts 2 and washers 3. (LT-R450K8 3-6)
3) Check the IAP sensor coupler for loose or poor contacts.
If OK, then check the IAP sensor lead wire continuity.
4) Disconnect the IAP sensor coupler.
5) Check the continuity between Red wire A and G/B wire B.
If the sound is not heard from the tester, the circuit condition
is OK.
1
YES Go to Step 2.
NO
• Loose or poor contacts on the ECM coupler
(terminal C or N).
• Open or short circuit in the Red wire or B/Br
wire.
1
V
1
1
To Next Page
Loading...
