6 LT-R450/ZK9 (’09-MODEL)
OIL JET
REMOVAL
• Separate the left and right crankcase. (LT-R450K8 3-22)
• Remove the piston cooling oil jet 1 from the right crankcase.
INSPECTION AND CLEANING
• Check the oil jet for clogging.
• If they are clogged, clean their oil passage with a proper wire
and compressed air.
INSTALLATION
• Apply engine oil to the O-ring 1.
• Install the piston cooling oil jet 2.
• Apply a small quantity of THREAD LOCK to the piston cooling
oil jet bolt, and then tighten the bolt.
99000-32110: THREAD LOCK SUPER “1322”
or equivalent
Use a new O-ring to prevent oil leakage.
To Next Page
Loading...
