26 LT-R450/ZK9 (’09-MODEL)
BRAKE PEDAL
REMOVAL
• Remove the brake pedal cover 1 and clip 2.
• Remove the cotter pin 3 and washer 4.
• Remove the master cylinder rod pin 5.
• Remove the brake pedal pivot bolt 6.
• Remove the return spring 7 and brake pedal 8.
INSTALLATION
Install the brake pedal in the reverse order of removal. Pay
attention to the following points:
• Apply grease to the oil seal and brake pedal pivot bolt.
99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Tighten the brake pedal pivot bolt 1 to the specified torque.
Brake pedal pivot bolt: 29 N·m (2.9 kgf-m, 21.0 lbf-ft)
• Install the return spring 2 properly. (Page 34)
• Install cotter pins and clip.
• Adjust the brake pedal height. (Page 4)
Replace the removed cotter pin with a new one.
To Next Page
Loading...
