22 LT-R450/ZK9 (’09-MODEL)
REMOVAL
• Remove the front fender. (LT-R450K8 7-6)
• Remove the fuel tank and fuel tank lower cover.
(LT-R450K8 5-4)
• Remove the rubber cap 1.
• Disconnect the fuel injector coupler 2, IAP sensor coupler 3
and TP sensor coupler 4.
• Remove the throttle cable cover 5.
• Disconnect the throttle cable from drum.
• Loosen the throttle body clamp screws and move the throttle
body assembly upward.
• Disconnect the starter cable from the throttle body assembly.
After disconnecting the throttle cables, do not snap
the throttle valve from full open to full close. It may
cause damage to the throttle valve and throttle body.
To Next Page
Loading...
