EasyManua.ls Logo

Suzuki DF100A - Throttle Tension Adjustment; Idle Speed Adjustment; Setting of Tilt Upper Limit Position

Suzuki DF100A
133 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
THROTTLE TENSION ADJUSTMENT
The tension of the remote control handle can be
adjusted according to your preference. To
increase the tension, turn the adjuster A clock-
wise. To decrease the tension, turn the adjuster
counterclockwise.
NOTE:
Top mount type
When adjusting the tension of the remote con-
trol handle, consult your authorized Suzuki
Marine Dealer.
IDLE SPEED ADJUSTMENT
The idle speed has been factory adjusted
between 650 – 750 r/min. in neutral.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
Side mount
type
SETTING OF TILT UPPER LIMIT POSITION
If the outboard motor contacts the motor well of
the boat during full tilt up operation, the upper
limit setting should be reset.
Perform this set-up after the current position
setting has been canceled, as explained in the
following procedure.
CANCELING THE TILT UPPER POSITION
LIMIT SETTING
1. Turn the ignition key to the “ON” position.
2. Pull out the emergency stop switch lock
plate.
3. Make sure that remote control handle is in
“NEUTRAL”.

Table of Contents

Related product manuals