89
Engine vibrates excessively:
• Propeller is damaged.
• Engine mounting bolts or clamp screws are
loose.
The Keyless Start System does not turn
ON even when the engine switch is oper-
ated. The error sound (three short buzzer
beeps) is NOT
heard:
(If equipped with Keyless Start System)
• Emergency stop switch lock plate is not in
position.
• Battery terminal connection is corroded or
lost.
• Battery power is lost.
• Keyless control unit failure.
• Electric wiring connection is loose.
• Engine switch panel failure.
The Keyless Start System does not turn
ON even when the engine switch is oper-
ated. The error sound (three short buzzer
beeps) IS
heard:
(If equipped with Keyless Start System)
• Keyless fob is outside the operating range.
• Keyless fob battery is dead.
• Keyless fob is in OFF mode.
• The keyless fob is not authenticated.
• Communication failure due to strong radio
wave or noise.
• Electric wiring connection failure between the
keyless control unit and outboard motor.
• Authentication error between the keyless
control unit and outboard motor.
• Abnormality exists in the electronic control
system of the engine.
The Keyless Start System does not turn
OFF even when the engine switch is oper-
ated:
• Electric wiring connection is loose.
• Engine switch panel failure.
FUSE
1. If equipped with Keyless Start System:
Turn the Keyless Start System OFF.
If not equipped with Keyless Start System:
Turn the ignition key to the “off” position.
2. Remove the motor cover.
3. Remove the fuse box cover and pull off the
fuse.
NOTE:
Use the fuse puller at the back of fuse box
cover, when the fuse is pulled off and installed.
Fuse box cover
To Next Page
Loading...
