23
To lower the motor back down:
1. Move the tilt lock lever 1 to the lock position.
2. Pull the motor slightly towards you and
slowly let the motor down.
NOTICE
If you use the tilt up lock arm to hold the
motor in the fully tilted position for trailering,
the tilt up lock arm could release resulting in
damage to the motor.
When trailering your boat, never use the tilt up
lock arm to hold the motor in the fully tilted
position.
SHALLOW WATER POSITION
To set the shallow water position:
1. Shift into “NEUTRAL”.
2. Move the tilt lock lever 1 to the release posi-
tion.
3. Slowly tilt the motor up until you hear it make
a “click” sound.
4. Slowly lower the motor. It will stop in a posi-
tion that is slightly tilted up from the normal
trim angle.
NOTE:
There are two shallow water positions. Use
whichever one is appropriate, depending on the
depth of the water.
To Next Page
Loading...
