Suzuki DR600S - Charging System Inspection

CHARGING
SYSTEM
INSPECTION
CHARGING
OUTPUT
CHECK
e@
Remove
the
left
and
right
frame
covers
and
seat.
(Refer
to
page
3-2)
Start
the
engine
and
keep
it
running
at
5000
r/min
with
lighting
switch
turned
ON
and
dimmer
switch
turned
HI
position.
e Using the pocket tester, measure the DC voltage
between the battery terminals, ® and ©.
If
the
tester
reads
under
13.5V
or
over
15.5V,
check
the
AC
generator
no-load
performance
or
replace the regulator/rectifier.
NOTE:
When making this test, be sure that the
battery is fully-charged condition.
STD charging 13.5 — 15.5V (DC)
output at 5 000 r/min
09900-25002 Pocket tester
AC GENERATOR NO-LOAD PERFORMANCE
© Remove the left frame cover.
©
Disconnect
the
AC
generator
lead
wire
connec-
tor
from
the
regulator/rectifier.
©
Start
the
engine
and
keep
it
running
at
5000
r/min.
©
Using
the
pocket
tester,
measure
the
AC
voltage
between
the
three
yellow
lead
wires.
If
the
tester
reads
under
80V,
the
AC
generator
(stator
or
rotor)
is
faulty.
STD No-load per-
formance (when
engine is cold)
hs
09900-25002
Pocket
tester
More than 80V (AC)
at 5000 r/min
ELECTRICAL
SYSTEM
54