Suzuki GSF1200S 2001 User Manual

ELECTRICAL SYSTEM 6-43
• After the electrolyte container is completely empty, remove it
from the battery and wait about 20 minutes.
• Insert the caps 1 firmly into the filler holes so that the top of
the caps do not protrude above the upper surface of the battery’s
top cover.
"
* The charging system for an MF battery is different from
that of a conventional battery. Only use the specified
MF battery.
* Do not tap the caps with a hammer when inserting
them.
* Do not remove the caps once they are installed in the
battery.
• Measure the battery voltage with a tester. The tester should
indicate more than 12.6 V (DC), as shown. If the battery volt-
age is lower than specification, charge the battery with a bat-
tery charger.
NOTE:
Initial charging for a new battery is recommended if two years
have elapsed since the date of manufacture.
SERVICING
Visually inspect the surface of the battery container. If any signs
of cracking or electrolyte leakage from the sides of the battery
have occurred, replace the battery with a new one. If the battery
terminals are found to be coated with rust or an acidic white pow-
dery substance, clean the battery terminals with sandpaper.
CORRECT
INCORRECT
30 seconds
(at 25°C)
Time
(Minutes)

Suzuki GSF1200S 2001 Specifications

General

Displacement	1157 cc
Compression Ratio	9.5:1
Ignition	Electronic ignition (Transistorized)
Transmission	5-speed
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Front Brakes	Dual disc
Rear Brakes	Single disc
Front Tire	120/70-ZR17
Rear Tire	180/55-ZR17
Seat Height	790 mm (31.1 inches)
Engine Type	4-stroke, 4-cylinder, DOHC
Cooling System	Air/oil-cooled
Rear Suspension	Swingarm, link type, coil spring, oil damped
Fuel Tank Capacity	20 liters
Bore x Stroke	79.0 mm x 59.0 mm