2-10
(Keyless Start Model)
Operation of the main switch knob becomes
possible by operation of the keyless start
system. For detail of the operation, refer to
KEYLESS START SYSTEM selection.
The ignition switch has 4 position.
“ (OFF)” Position
All electrical circuits are cut off. The engine
will not start.
“ (ON)” Position
The ignition circuit is completed and the
engine can now be started. The taillight will
automatically be turned on when the main
switch knob is in this position.
NOTE: Start the engine promptly after turn-
ing the key to the “ (ON)” position, or the
battery will lose power due to consumption
by the taillight.
“ (ACC)” Position
All electrical circuits are cut off and the main
switch knob can be pulled out. A key is
attached to the main switch knob and the
key is commonly used for fuel tank cap and
rear seat lock. For the detail, refer to FUEL
TANK CAP, SEAT LOCK.
To Next Page
Loading...
