4-45
INSTRUMENT CLUSTER
69TB-01E
When the power steering control system
cools down, the power steering system
will return to its original condition.
However, repeating these operations
could cause damage to the power steer-
ing system.
• If the power steering system does not
work properly, it will require greater effort
to steer, but you still will be able to steer.
• If the steering is operated, you may hear
noise caused by electric power steering
operation. This is normal and indicates
that the power steering system works
properly.
Engine oil pressure warning light
80J223
When the engine switch is pressed to
change the ignition mode to ON, this light
comes on. When the engine is started, the
light goes out. The light will come on and
remain on if there is insufficient oil pres-
sure. If the light comes on when driving,
pull off the road as soon as you can and
stop the engine.
Check the oil level and add oil if necessary.
If there is enough oil, the lubrication sys-
tem should be inspected by an authorized
SUZUKI dealer or a qualified workshop
before you drive the vehicle again.
Charge warning light
80J226
When the engine switch is pressed to
change the ignition mode to ON, this light
comes on. When the engine is started, the
light goes out. The light will come on and
remain on if there is something wrong with
the battery charging system. If the light
comes on when the engine is running, the
charging system should be inspected
immediately by an authorized SUZUKI
dealer or a qualified workshop.
NOTICE
• If you operate the engine with this
light on, severe engine damage can
result.
• Do not rely on the oil pressure light
to indicate the need to add oil. Peri-
odically check the engine oil level.
To Next Page
Loading...
Need help?
General
