5-10
OPERATING YOUR VEHICLE
69TB-01E
the instrument panel or in the luggage
compartment.
NOTE:
• Even when the remote controller is in the
interior workable area, if it is in any of the
following conditions, you may not be
able to start the engine or select the igni-
tion modes, and the remote controller
outside warning may be given.
–The remote controller’s battery is low.
–The remote controller is affected by
strong radio wave or noise.
–The remote controller is in contact with
or covered by a metallic object.
–The remote controller is in the secluded
stowages such as the glove box or a
door pocket.
–The remote controller is in the sun visor
pocket or on the floor.
• Even when the remote controller is out-
side the interior workable area, if it is in
any of the following conditions, you may
be able to start the engine or select the
ignition mode. The remote controller out-
side warning may not be given at that
time.
–The remote controller is outside the
vehicle but very close to a door.
–The remote controller is on the instru-
ment panel.
Engine switch illumination
The engine switch is illuminated (lit) in the
following situations:
• When the engine is off and the driver’s
door is open, or for 15 seconds after the
driver’s door is closed. The illumination
will fade out after 15 seconds passed.
• When the engine is off and the position
lights are on. The illumination will go out
when the position lights are turned off.
• When the engine is on and the position
lights and/or the headlights are on. The
illumination will go out when the position
lights and the headlights are turned off.
82K253
NOTE:
To save the lead-acid battery, the illumina-
tion will be automatically turned off when
both of the following conditions are simul-
taneously met:
• The headlights and position lights are
turned off.
• 15 minutes has elapsed since opening
the driver’s door.
Selection of ignition modes
Press the engine switch to select ACC or
ON mode as follows when you use an
electric accessory or check the operation
of instruments without running the engine.
1) Bring the keyless push start system
remote controller with you and sit in the
driver’s seat.
2) Manual transmission – Without
depressing the clutch pedal, press the
engine switch (1).
CVT – Without depressing the brake
pedal, press the engine switch (1).
82K254
3) Without depressing the brake pedal,
press the engine switch (1).
(1)
To Next Page
Loading...
Need help?
General
